Owner manual

KINO-DH810
Page 18
The AT/ATX mode select switch specifies the systems power mode as AT or ATX.
AT/ATX mode select switch settings are shown in Table 3-3.
Setting Description
Short 2-3 AT Mode
Short 1-2 ATX Mode Default
Table 3-3: AT/ATX Mode Select Switch Settings
The location of the AT/ATX mode select switch is shown in Figure 3-2 below.
Figure 3-2: AT/ATX Mode Select Switch Location
3.2.2 Battery Connector
CN Label:
BAT1
CN Type:
2-pin wafer
CN Location:
See Figure 3-3
CN Pinouts:
See Table 3-4
The battery connector is connected to the system battery. The battery provides power to
the system clock to retain the time when power is turned off.