Manual

KINO-DH610
Page 49
Setting Description
Open ATX Mode
Short AT Mode Default
Table 4-2: AT/ATX Mode Select Jumper Settings
The location of the AT/ATX mode select jumper is shown in Figure 4-9 below.
Figure 4-9: AT/ATX Mode Select Jumper Location
4.4.2 Clear CMOS Jumper
Jumper Label: J_CMOS1
Jumper Type:
3-pin header
Jumper Settings:
See Table 4-3
Jumper Loc
ation:
See Figure 4-10
If the KINO-DH610 fail
s to boot due to improper BIOS settings, the clear CMOS jumper
clears the CMOS data and resets the system BIOS information. To do this, use the jumper
cap to close pins 2 and 3 for a few seconds then reinstall the jumper clip back to pins 1
and 2.