Instruction Manual

KINO-CVR-D25502/N26002
Page 64

Disabled
Disables the use of hyper-threading technology

Enabled DEFAULT
Enables the use of hyper-threading technology
5.3.5 S ATA Configuration
Use the SATA Configuration menu (BIOS Menu 7) to change and/or set the
configuration of the SATA devices installed in the system.
Aptio Setup Utility – Copyright (C) 2011 American Megatrends, Inc.
Advanced
SATA Configuration
SATA Port1 Not Present
SATA Port2 Not Present
SATA Port3 Not Present
SATA Port4 Not Present
SATA Port5 Not Present
SATA Port6 Not Present
SATA Mode [IDE Mode]
Serial-ATA Controller 0 [Compatible]
Serial-ATA Controller 1 [Enhanced]
(1) IDE Mode. (2) AHCI
Mode. (3) RAID Mode.
---------------------
 : Select Screen
↑ ↓: Select Item
Enter Select
+/-: Change Opt.
F1 General Help
F2 Previous Values
F3 Optimized Defaults
F4 Save & Exit
ESC Exit
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
BIOS Menu 7: IDE Configuration
 SATA Mode [IDE Mode]
Use the SATA Mode option to configure SATA devices as normal IDE devices.

IDE Mode DEFAULT
Configures SATA devices as normal IDE device.

ACHI Mode
Configures SATA devices as AHCI device.

RAID Mode
Configures SATA devices as RAID device.
 Serial-ATA Controller 0 [Compatible]
Use the Serial-ATA Controller 0 option to configure the Serial-ATA controller mode when
the SATA mode is set to IDE Mode.