Instruction Manual

KINO-CVR-D25502/N26002
Page 50
To connect a digital display device to the KINO-CVR-D25502/N26002, please follow the
instructions below.
Step 1: Locate the HDMI connector. The location of the HDMI connector is shown in
another chapter.
Step 2: Align the HDMI connector. Align the male HDMI connector on the digital
display device cable with the female HDMI connector on the external peripheral
interface.
Step 3: Insert the HDMI connector. Once the connectors are properly aligned with the
male connector, insert the male connector from the digital display device into the
female connector on the KINO-CVR-D25502/N26002.
Step 4: Secure the connector. Secure the HDMI connector from the digital display
device to the external interface by tightening the two retention screws on either
side of the connector. Step 0:
4.6.3 LAN Connection
There are two external RJ-45 LAN connectors. The RJ-45 connector enables connection
to an external network. To connect a LAN cable with an RJ-45 connector, please follow
the instructions below.
Step 1: Locate the RJ-45 connectors. The location of the LAN connectors is shown in
Chapter 3.
Step 2: Align the connectors. Align the RJ-45 connector on the LAN cable with one of
the RJ-45 connectors on the KINO-CVR-D25502/N26002. See Figure 4-7.