Instruction Manual

KINO-CVR-D25502/N26002
Page 46
The AT/ATX mode select jumper specifies the systems power mode as AT or ATX.
AT/ATX mode select jumper settings are shown in Table 4-2.
Setting Description
Open AT Mode
Short ATX Mode Default
Table 4-2: AT/ATX Mode Select Jumper Settings
The location of the AT/ATX mode select jumper is shown in Figure 4-3 below.
Figure 4-3: AT/ATX Mode Select Jumper Location
4.5 In te rnal Peripheral Device Connections
This section outlines the installation of peripheral devices to the on-board connectors
4.5.1 SATA Drive Connection
The KINO-CVR-D25502/N26002 is shipped with two SATA drive cables and one SATA
drive power cable. To connect the SATA drives to the connectors, please follow the steps
below.
Step 1: Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.