Manual

KINO-AQ870
Page 19
CN Location:
See Figure 3-3
The AT/ATX mode select switch specifies the systems power mode as AT or ATX.
AT/ATX mode select switch settings are shown in Table 3-4.
Setting Description
Short 1-2 AT Mode
Short 2-3 ATX Mode Default
Table 3-4: AT/ATX Mode Select Switch Settings
The location of the AT/ATX mode select switch is shown in Figure 3-3 below.
Figure 3-3: AT/ATX Mode Select Switch Location
3.2.3 Battery Connector
CN Label:
BAT1
CN Type:
2-pin wafer
CN Location:
See Figure 3-4
CN Pinouts:
See Table 3-5
The battery connector is connected to the system battery. The battery provides power to
the system clock to retain the time when power is turned off.