User Manual

KINO-AQ670
Page 48
Setting Description
Open AT Mode
Short ATX Mode Default
Table 4-2: AT/ATX Mode Select Jumper Settings
The location of the AT/ATX mode select jumper is shown in Figure 4-9 below.
Figure 4-9: AT/ATX Mode Select Jumper Location
4.4.2 Clear CMOS Jumper
Jumper Label: J_CMOS 2
Jumper Type:
3-pin header
Jumper Settings: See Table 4-3
Jumper Location: See Figure 4-10
If the KINO-AQ670 fails to boot due to improper BIOS settings, the clear CMOS jumper
clears the CMOS data and resets the system BIOS information. To do this, use the jumper
cap to close pins 2 and 3 for a few seconds then reinstall the jumper clip back to pins 1
and 2.