Manual

KINO-9652 Mini-ITX SBC
Page 96
cable with the female DB-15 connector on the external peripheral interface.
Step 3: Insert the VGA connector. Once the connectors are properly aligned with the
insert the male connector from the VGA screen into the female connector on the
KINO-9652. See
Figure 5-20.
Figure 5-20: VGA Connector
Step 4: Secure the connector. Secure the DB-15 VGA connector from the VGA
monitor to the external interface by tightening the two retention screws on either
side of the connector. Step 0:
5.7.4 Serial Device Connection
The KINO-9652 has one female DB-9 connector on the external peripheral interface panel
for serial devices. Follow the steps below to connect a serial device to the KINO-9652.
Step 1: Locate the DB-9 connector. The location of the DB-9 connector is shown in
Chapter 3.
Step 2: Insert the serial connector. Insert the DB-9 connector of a serial device into
the DB-9 connector on the external peripheral interface. See
Figure 5-21.