Instruction Manual

KINO-945GSE2 Motherboard
Page 98

COM1 DEFAULT
System is remotely accessed through COM1

COM2
System is remotely accessed through COM2
NOTE: Make sure the selected COM port is enabled through the Super I/O configuration
menu.
 Base Address, IRQ [2F8h,3]
The Base Address, IRQ option cannot be configured and only shows the interrupt
address of the serial port listed above.
 Serial Port Mode [115200 8,n,1]
Use the Serial Port Mode option to select baud rate through which the console redirection
is made. The following configuration options are available
 115200 8,n,1 D
EFAULT
 57600 8,n,1
 38400 8,n,1
 19200 8,n,1
 09600 8,n,1
NOTE:
Identical baud rate setting musts be set on the host (a management
computer running a terminal software) and the slave
 Flow Control [None]
Use the Flow Control option to report the flow control method for the console redirection
application.

None DEFAULT
No control flow,

Hardware
Hardware is set as the console redirection

Software
Software is set as the console redirection