User Manual

KINO-945GSE Motherboard
Page 85
5.9 External Peripheral Interface Connection
The following external peripheral devices can be connected to the external peripheral
interface connectors.
 RJ-45 Ethernet cable connectors
 PS/2 devices
 Serial port devices
 USB devices
 VGA monitors
To install these devices, connect the corresponding cable connector from the actual
device to the corresponding KINO-945GSE external peripheral interface connector
making sure the pins are properly aligned.
5.9.1 LAN Connection (Single Connector)
There are two external RJ-45 LAN connectors. The RJ-45 connectors enable connection
to an external network. To connect a LAN cable with an RJ-45 connector, please follow
the instructions below.
Step 1: Locate the RJ-45 connectors. The locations of the USB connectors are shown
in Chapter 4.
Step 2: Align the connectors. Align the RJ-45 connector on the LAN cable with one of
the RJ-45 connectors on the KINO-945GSE. See
8Figure 5-14.