User Manual

IVCE-C608/IVCE-C604/IVCME-C604 Capture Card
Page 22
Figure 5-7: Video Output Connection
Step 1: Align and insert the DB-26 male connector from the cable to the DB-26 female
connector on the board.
Step 2: Make sure the connection is secure.
Step 3: Connect the video output BNC connector (yellow) from the cable to a video
device with the BNC cables.
Step 4: Repeat Step 3 to connect the second video output device.Step 0:
5.5 IVCME-C604 Hardware Installation
5.5.1 Hardware Installation Procedures
To install the video capture card hardware, the following steps must be followed:
Step 1: Install the video capture card.
Step 2: Install the GPIO card (optional).
Step 3: Connect the video and audio devices.Step 0:
Once the steps above have been completed, the hardware installation procedures are
complete.