User Manual
Table Of Contents
- 1 Introduction
- 2 Unpacking
- 3 Connectors
- 3.1 Peripheral Interface Connectors
- 3.2 Internal Peripheral Connectors
- 3.2.1 ATX Power Enable Connector
- 3.2.2 Audio Connector (10-pin)
- 3.2.3 Backlight Inverter Connector
- 3.2.4 Battery Connector
- 3.2.5 CompactFlash® Socket
- 3.2.6 Digital Input/Output (DIO) Connector
- 3.2.7 Fan Connector (+5V)
- 3.2.8 Floppy Disk Connector
- 3.2.9 Front Panel Connector (8-pin)
- 3.2.10 IDE Connector (40-pin)
- 3.2.11 Infrared Interface Connector (5-pin)
- 3.2.12 Keyboard/Mouse Connector
- 3.2.13 Parallel Port Connector
- 3.2.14 Power Connector
- 3.2.15 SATA Drive Connectors (Optional)
- 3.2.16 Serial Port Connector (RS-232/422/485)
- 3.2.17 TTL Connector
- 3.2.18 Internal USB Connectors
- 3.2.19 -VCC Power Connector
- 3.3 External Peripheral Interface Connectors
- 4 Installation
- 5 BIOS Screens
- A BIOS Menu Options
- B One Key Recovery
- C Terminology
- D Watchdog Timer
- E Hazardous Materials Disclosure

IOWA-LX-600 Half-size CPU Card
Page 137
PCIe PCI Express (PCIe) is a communications bus that uses dual data lines
for full-duplex (two-way) serial (poi nt-to-point) communicatio ns between
the SBC components and/or exp ansion cards and the SBC chipsets.
Each line has a 2.5 Gbps data transmission rate and a 250 MBps
sustain ed data transfer rate.
POST The Power-on Self Test (POST) is the pre-boot actions the system
performs when the system is turned-on.
QVGA Quarter V ideo Graphics Array (QVGA) refers to a display with a
resolution of 320 x 240 pixels.
RAM Random Access Memory (RAM) is a form of storage used in computer.
RAM is volatile memory, so it loses its data when power is lost. RAM
has very fast data tra nsfer rates compared to other storage like hard
drives.
SATA Serial ATA (SATA) is a serial communications bus designed for data
transfers between storage device s and the computer chipsets. The
SATA bus has transfer speeds up to 1.5 Gbps and the SATA 3Gb/s bus
has data transfer speeds of up to 3.0 Gbps.
S.M.A.R.T Self Monitoring Analysis and Reporting Technology (S.M.A.R.T) refers
to automatic statu s checking technology implemented on hard disk
drives.
UART Universal Asynchronous Receiv e r-tran smitter (UART) is responsible for
asynchronous communications on the system and manages the
system’ s seri al communication (COM) ports.
UHCI The Universal Host Controller Interface (UHCI) specification is a
register-level interface description for USB 1.1 Host Controllers.
USB The Universal Serial Bus (USB) is an external bus standard for
interfacing devices. USB 1.1 support s 12Mbp s data transfer rates, while










