Owner manual

IOVU-751R-CE5/UX-R10 User Manual
Page 34
Step 5: Tighten the screws that pass through the panel mounting clamps until the plastic
caps at the front of all the screws are firmly secured to the panel (
220H220HFigure 4-14).
Figure 4-14: Tighten the Panel Mounting Clamp Screws
4.3.3 Arm Mounting
The IOVU-751R-CE5/UX-R10 is VESA (Video Electronics Standards Association)
compliant and can be mounted on an arm with a 75 mm interface pad. To mount the
IOVU-751R-CE5/UX-R10 on an arm, please follow the steps below.
Step 1: The arm is a separately purchased item. Please correctly mount the arm onto
the surface it uses as a base. To do this, refer to the installation documentation
that came with the mounting arm.
NOTE:
When purchasing the arm please ensure that it is VESA compliant and that
the arm has a 75 mm interface pad. If the mounting arm is not VESA
compliant it cannot be used to support the IOVU-751R-CE5/UX-R10.