Manual

IMBA-Q670 ATX Motherboard
Page 68
Figure 4-19: USB Connector
4.5.8 VGA Monitor Connection
The IMBA-Q670 has a single female D-sub 15 connector on the external peripheral
interface panel. The D-sub 15 connector is connected to a CRT or VGA monitor. To
connect a monitor to the IMBA-Q670, please follow the instructions below.
Step 1: Locate the female D-sub 15 connector. The location of the female D-sub 15
connector is shown in Chapter 3.
Step 2: Align the VGA connector. Align the male D-sub 15 connector on the VGA
screen cable with the female D-sub 15 connector on the external peripheral
interface.
Step 3: Insert the VGA connector. Once the connectors are properly aligned with the
insert the male connector from the VGA screen into the female connector on the
IMBA-Q670. See
Figure 4-20.