User guide

IMBA-9454G Motherboard
Page 125


COM3 DEFAULT
System is remotely accessed through COM3


COM4 DEFAULT
System is remotely accessed through COM4


COM5 DEFAULT
System is remotely accessed through COM5


COM6 DEFAULT
System is remotely accessed through COM6
NOTE: Make sure the selected COM port is enabled through the Super I/O configuration
menu.
 Base Address, IRQ [3F8h, 4]
The Base Address, IRQ option cannot be configured and only shows the interrupt
address of the serial port listed above.
 Serial Port Mode [115200 8,n,1]
Use the Serial Port Mode option to select baud rate through which the console redirection
is made. The following configuration options are available.
 115200 8,n,1 D
EFAULT
 57600 8,n,1
 38400 8,n,1
 19200 8,n,1
 09600 8,n,1
NOTE:
Identical baud rate settings must be set on the host (a management
computer running terminal software) and the slave.
 Redirection After BIOS POST [Always]
Use the Redirection After BIOS POST option to specify when console redirection should
occur.


Disabled
The console is not redirected after POST.