Instruction Manual

IDS-H61 Digital Signage Player
Page 43
Step 3: Remove the mSATA module. Push the two spring clips in to release the
mSATA module.
Step 4: Insert a new mSATA module into the socket at an angle. Line up the notch
on the card with the notch on the connector. Slide the mSATA module into the
socket at an angle of about 20º (
Figure 5-3).
Figure 5-3: mSATA Module Installation
Step 5: Push down until the card clips into place. Push the other end of the card
down until it clips into place on the plastic connector.Step 0:
5.2.2 SO-DIMM Replacement
WARNING:
Using incorrectly specified SO-DIMM may cause permanently damage
the IDS-H61. Please make sure the purchased SO-DIMM complies
with the memory specifications of the IDS-H61.
To replace a SO-DIMM memory module into a SO-DIMM socket, please follow the steps
below.