User's Manual

ICEFIRE-T10A Mobile Clinic Assistant
Page 31
3.5.2 VGA Monitor Connection
The ICEFIRE-T10A Docking Station has a single female DB-15 connector on the bottom
peripheral interface panel. The DB-15 connector is connected to a CRT or VGA monitor.
To connect a second monitor to the ICEFIRE-T10A, please follow the instructions below.
Step 1: Locate the female DB-15 connector. The location of the female DB-15
connector is shown in 414H491H Figure 3-18.
Step 2: Align the VGA connector. Align the male DB-15 connector on the VGA screen
cable with the female DB-15 connector on the external peripheral interface.
Step 3: Insert the VGA connector. Once the connectors are properly aligned with the
insert the male connector from the VGA screen into the female connector on the
ICEFIRE-T10A. See 415H492H Figure 3-21.
Figure 3-21: VGA Connector
Step 4: Secure the connector. Secure the DB-15 VGA connector from the VGA
monitor to the external interface by tightening the two retention screws on either
side of the connector. Step 0: