User's Manual

ICEFIRE-T10A Mobile Clinic Assistant
Page 25
Step 2: Open the rubber cover.
Step 3: Align the connectors. Align the USB device connector with the connector on
the ICEFIRE-T10A. See figure below.
Figure 3-12: USB Device Connection
Step 4: Insert the device connector. Once aligned, gently insert the USB device
connector into the on-board connector. Step 0:
3.4 Smart Card Reader Installation (Optional)
To install the optional smart card reader, please follow the steps below.
Step 1: Locate the USB port on the right side panel.
Step 2: Connect the smart card reader to the USB port on the side panel ( 487H Figure 3-13).