User's Manual

ICEFIRE-T10A Mobile Clinic Assistant
Page 24
3.3 I/O Connectors
3.3.1 LAN Connection
The RJ-45 connectors enable connection to an external network. To connect a LAN cable
with an RJ-45 connector, please follow the instructions below.
Step 1: Locate the RJ-45 connector on the rear panel. The locations of the USB
connectors are shown in 409H484H Figure 1-4 in Chapter 1.
Step 2: Open the rubber cover.
Step 3: Align the connectors. Align the RJ-45 connector on the LAN cable with one of
the RJ-45 connectors on the bottom panel. See 410H485H Figure 3-11.
Figure 3-11: LAN Connection
Step 4: Insert the LAN cable RJ-45 connector. Once aligned, gently insert the LAN
cable RJ-45 connector into the onboard RJ-45 port. Step 0:
3.3.2 USB Device Connection
There is one USB 2.0 connector located on the right side of the ICEFIRE-T10A. To
connect a USB 2.0 or USB 1.1 device, please follow the instructions below.
Step 1: Located the USB connector. The location of the USB connector is shown
in 411H486H Figure 1-5.