User's Manual

ICEFIRE-T10A Mobile Clinic Assistant
Page 95
NOTE:
Installing unsupported OS versions may cause the recovery tool to fail.
B.2 Setup Procedure for Windows
Prior to using the recovery tool to backup or restore Windows system, a few setup
procedures are required.
Step 1: Hardware and BIOS setup (see Section 769H769H450H533H B.2.1)
Step 2: Create partitions (see Section 770H770H451H534H B.2.2)
Step 3: Install operating system, drivers and system applications (see Section 771H771H452H535H B.2.3)
Step 4: Build-up recovery partition (see Section 772H772H453H536H B.2.4)
Step 5: Create factory default image (see Section 773H773H454H537H B.2.5) Step 0:
The detailed descriptions are described in the following sections.
NOTE:
The setup procedures described below are for Microsoft Windows
operating system users. For Linux system, most setup procedures are
the same with Microsoft Windows except for several steps which is
described in Section 774H774H455H538H B.3.
B.2.1 Hardware and BIOS Setup
Step 1: Make sure the system is powered off and unplugged.
Step 2: Install a hard drive or SSD in the system. An unformatted and unpartitioned disk
is recommended.
Step 3: Connect an optical disk drive to the system and insert the recovery CD.