Instruction Manual

IBX-530B-270 Embedded System
Page 33
Figure 4-2: Bottom Cover Retention Screws (Rear Panel)
Step 3: Gently remove the bottom cover from the IBX-530B-N270. Step 0:
4.2.4 Configure the Jumper Settings
To configure the jumper settings, please follow the steps below.
Step 1: Remove the bottom cover. See Section
4.2.3.
Step 2: Locate the jumper settings on the embedded motherboard. See Section
3.5.
Step 3: Make the jumper settings in accordance with the settings described and defined
in Section
3.5.
4.2.5 CompactFlash® Card Installation
The IBX-530B-N270 embedded system has one CF slot on left side panel. To install the
CF card, follow the instructions below.
Step 1: Locate the CF card slot rubber cover on the left side panel.
Step 2: Remove CF card slot rubber cover.
Step 3: Insert the CF card into the slot. (
Figure 4-3).