Instruction Manual

IBX-530B-270 Embedded System
Page 20
3.5.1 Access the Jumpers
To access the jumpers, remove the back panel. To remove the back panel, please refer to
Section
4.2.3.
3.5.2 AT Power Select Jumper Settings
Jumper Label: JP4
Jumper Type:
2-pin header
Jumper Settings:
See Table 3-2
Jumper Location:
See Figure 3-2
The AT Power Select jumper specifies the systems power mode as AT or ATX. AT Power
Select jumper settings are shown in
Table 3-2.
Setting Description
Short Use ATX power Default
Open Use AT power
Table 3-2: AT Power Select Jumper Settings
The location of the AT Power Select jumper is shown in Figure 3-2 below.
Figure 3-2: AT Power Select Jumper Location