Instruction Manual

IBX-530B-270 Embedded System
Page 19
3.5 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three metal
pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect
them. To CLOSE/SHORT a jumper means
connecting the pins of the jumper with the plastic
clip and to OPEN a jumper means removing the
plastic clip from a jumper.
The following jumpers can be found on the motherboard installed in the IBX-530B-N270.
Before the IBX-530B-N270 is installed, the jumpers must be set in accordance with the
desired configuration. The jumpers on the IBX-530B-N270 motherboard are listed in
Table 3-1.
Description Label Type
AT/ATX mode select JP4 2-pin header
CF mode select JCF1 2-pin header
Clear CMOS J_COMS1 2-pin header
COM1 Pin 9 setting JP8 10-pin header
COM3 Pin 9 setting JP10 6-pin header
COM3 RX RS-232/422/485 select JP9 8-pin header
COM3 TX RS-422/485 select JP11 6-pin header
COM3 RS-232/422/485 select JP6 12-pin header
Table 3-1: Jumpers