Owner's manual

HDC-4x Series Video Capture Card
Page 12
2.2 Hardware Installation Procedure
To install the video capture card hardware, the following steps must be followed:
Step 1: Install the video capture card.
Step 2: Install the DVI-I source equipment. Step 0:
Once the steps above have been completed, the hardware installation procedures are
complete.
2.3 Video Capture Card Installation
The HDC-4x Series video capture card has either a PCIe x1 or a PCI interface. To install
the HDC-4x Series, please follow the steps below:
Step 1: Align the PCIe/PCI edge connector on the bottom of the video capture card with
the PCIe x1 or PCI slot on the system motherboard.
Step 2: Gently insert the video capture card into the PCIe x1 or PCI slot.
Step 3: Push down gently on the video card to make sure it is firmly inserted into the
PCIe x1 or PCI slot.
HDC-401