Owner manual

HDC-3x Series Video Capture Card
Page 44
Figure 4-7: Select Transmitter Bus for HDC-304E
Step 8: Click Operation Start
to start decoding the selected video. Step 0:
4.4 Video Bypass
To view the video input source on HDMI display device in real time, please follow the
steps below.
Step 1: Launch the HDCapture.
Step 2: Connect the HDMI cable from HDMI display device to the HDMI output port or
the HDMI output kit (HDC-304E).
Step 3: Connect the video input source to the HDMI input port of the HDC-3x Series.
Step 4: This step is only required for the HDC-302E. Select the transmitter bus (0 or 1)
(
Figure 4-9). For example, to view the video input source 1 on HDMI display
device, select the transmitter bus 0. Please refer to the following table:
Video Input Source Transmitter Bus
Source 1 0
Source 2 1