Manual

HDC-3x Series SDK (Linux)
Page 27
Step 12: The following message shows. Select the codec chip that is used for decoding
the video. Please note that the codec chip options may vary by the installed
capture card. Step 0:
< Device list >
‘Z’<-~~~~~~~~~~~~~~~->Enter
Select following number. (* is current setting)
1 * Codec chip 0
2 Codec chip 1
3 Codec chip 2
4 Codec chip 3
fmb-0?>
NOTE:
To broadcast the encoding video directly, please select “1 Bypass
mode” from Step 5. When the following message shows, select the
input port that is used for encoding the video. Please note that the input
port options may vary by the installed capture card.
< Device list >
‘Z’<-~~~~~~~~~~~~~~~->Enter
Select following number. (* is current setting)
1 * Input 0
2 Input 1
3 Input 2
4 Input 3
fmb-0?>
1.6.3 Decoding
After configuring decoding settings and video I/O setting, the user can start decoding the
video by following the steps below.
Step 1: Access to the main menu. Type 2 to select “2 Decoding” from the main menu.