Owner manual

eKINO-945GSE Motherboard
Page 81
Step 2: Align the connectors. The cable has two connectors. Correctly align pin 1on
each cable connector with pin 1 on the eKINO-945GSE USB connector.
Step 3: Insert the cable connectors. Once the cable connectors are properly aligned
with the USB connectors on the eKINO-945GSE, connect the cable connectors
to the on-board connectors. See
Figure 5-9.
Figure 5-9: Dual USB Cable Connection
Step 4: Attach the bracket to the chassis. The USB 2.0 connectors are attached to a
bracket. To secure the bracket to the chassis please refer to the installation
instructions that came with the chassis.Step 0: