Manual

ECW-281B/281B2-R30/N270 Embedded System
Page 48
Step 5: Secure the HDD with the bracket by inserting four retention screws into the
bottom of the bracket (
77Figure 4-4).
Figure 4-4: HDD Retention Screws
Step 6: Locate the breather hole of the HDD. Cut off the corresponding area of the
breather hole from the thermal pad.
Step 7: Adhere the thermal pad to the HDD. Make sure there is no obstacle covering the
breather hole (
77Figure 4-5).
CAUTION:
Make sure the breather hole of the HDD is not covered. Covering the
breather hole may cause damage to the HDD.