Manual

ECW-281B/281B2-R30/N270 Embedded System
Page 46
Figure 4-1: Bottom Surface Retention Screws
Step 2: Gently remove the bottom surface from the ECW-281B/281B2-R30/N270.
Step 0:
4.2.4 Configure the Jumper Settings
To configure the jumper settings, please follow the steps below.
Step 1: Remove the bottom surface. See Section
774.2.3.
Step 2: Locate the jumper settings on the embedded motherboard. See Chapter
773.
Step 3: Make the jumper settings in accordance with the settings described and defined
in Chapter
773.
4.2.5 Hard Drive Installation
One 2.5” SATA hard drive supported. The SATA drive is installed into a hard drive bracket
attached on the inside of the bottom panel (
77Figure 4-2).