Manual

ECW-281B/281B2-R30/N270 Embedded System
Page 37
PIN DESCRIPTION PIN DESCRIPTION
1 RED 2 GREEN
3 BLUE 4 NC
5 GND 6 CRT_PLUG-
7 GND 8 GND
9 VCC 10 GND
11 NC 12 DDC DAT
13 HSYNC 14 VSYNC
15 DDCCLK
Table 3-18: VGA Connector Pinouts
3.5 WAFER-945GSE Motherboard On-board Jumpers
NOTE:
A
jumper is a metal bridge used to close
an electrical circuit. It consists of two or
three metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them. To
CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper
means removing the plastic clip from a
jumper.
Figure 3-18: Jumpers
The WAFER-945GSE motherboard has several onboard jumpers (77Table 3-19).
Description Label Type
CF Card Setting JCF1 2-pin header
Clear CMOS J_CMOS1 3-pin header