Owner manual

ECW-281B Embedded System
Page 55
 All peripheral devices (VGA monitor, serial communications devices etc.) are
connected
 The power cables are plugged in
 The system is securely mounted
4.3.2 Terminal Block Pinouts
The terminal block pinouts are shown in 769H769H769HFigure 4-14.
Figure 4-14: Terminal Block Pinouts
The chassis ground is connected to the ECW chassis internally. The cable ground is
connected to the ground pin on the input power connector of the power module.
4.3.3 Power-on Procedure
To power-on the ECW-281B/281B2-R20 please follow the steps below:
Step 1: Push the power button.
Step 2: Once turned on, the power button should turns to blue. See
770H770H770HFigure 4-15.
Step 0: