Owner manual

ECW-281B Embedded System
Page 46
Step 2: Gently remove the bottom surface from the ECW-281B/281B2-R20. Step 0:
4.2.4 Configure the Jumper Settings
To configure the jumper settings, please follow the steps below.
Step 1: Remove the bottom surface. See Section
751H751H751H4.2.3.
Step 2: Locate the jumper settings on the embedded motherboard. See Chapter
752H752H752H3.
Step 3: Make the jumper settings in accordance with the settings described and defined
in Chapter
753H753H753H3.
4.2.5 Hard Drive Installation
One 2.5” SATA hard drive supported. The SATA drive is installed into a hard drive bracket
attached on the inside of the bottom panel (
754H754H754HFigure 4-2).
Figure 4-2: Hard Drive Bracket
To install the hard drive into the system, please follow the steps below.
Step 1: Remove the bottom surface See Section
755H755H755H4.2.3.
Step 2: Remove the hard drive bracket from the bottom surface by removing the four
retention screws that secure the bracket to the bottom surface. (
756H756H756HFigure 4-3)