Owner manual

ECW-281B Embedded System

Page 45

1 Driver and manual CD

Wireless antenna (wireless model only)

1 VESA MIS-D 100 wall mount kit

(optional)

1 DIN mount kit (optional)

Table 4-1: Package List Contents

4.2.3 Bottom Surface Removal

Before the jumper settings can be configured and the hard disk drive can be installed, the

bottom surface must be removed. To remove the bottom surface, please follow the steps

below:

Step 1: Remove the bottom surface retention screws. The bottom surface is secured to

the chassis with six retention screws (

750H750H750HFigure 4-1). All six screws must be

removed.

Figure 4-1: Bottom Surface Retention Screws