Owner manual

ECW-281B Embedded System
Page 120
Step 4: Plug the system into a monitor and check to see if anything appears on the
screen. If the boot-up screen appears it means the power LED has become
disconnected. To fix this problem, open the top cover and reconnect the power
LED to the motherboard. Step 0:
If the above steps have been completed and the system still doesn’t turn on, please do the
following.
Step 1: Open the bottom surface (Section
835H835H835H4.2.3)
Step 2: Check the terminal block/power socket power cable connector is properly
connected to the power module.
Step 3: Check that the power button cable connector is properly connected to the
motherboard.
Step 4: Make sure the cable connecting to the terminal block/power socket are properly
attached and have not become separated.
Step 5: Make sure the cable connecting the power button to the motherboard is still
properly attached to the power button and has not been separated. Step 0:
7.2.2 The System Doesn’t Boot Up
If the system doesn’t boot up please do the following:
Step 1: Check the power is turned on. See Section
836H836H836H7.2.1 above.
Step 2: Make sure the SO-DIMM module is properly installed.
Step 3: Reset the system using the reset CMOS jumper. Step 0: