User guide

ECW-281B-D2550 Embedded System
Page 19
Step 6: Locate the breather hole of the HDD. Cut off the corresponding area of the
breather hole from the thermal pad.
Step 7: Adhere the thermal pad to the HDD. Make sure there is no obstacle covering the
breather hole (
765Figure 3-5).
CAUTION:
Make sure the breather hole of the HDD is not covered. Covering the
breather hole may cause damage to the HDD.
Figure 3-5: HDD Thermal Pad
Step 8: Replace the HDD bracket onto the bottom surface by aligning the four retention
screw holes in the HDD bracket with those in the back of the bottom surface.
Step 9: Reinsert the four previously removed retention screws.
Step 10: Connect the supplied SATA and power cable to the ECW-281B-D2550 and
HDD.
Step 11: Replace the bottom surface to the bottom panel by reinserting the ten previously
removed retention screws. Step 0: