User guide

ECW-281B-D2550 Embedded System
Page 114
Step 12: Enable the Auto Recovery Function option (Advanced  iEi Feature  Auto
Recovery Function).
BIOS SETUP UTILITY
Main Advanced PCIPNP Boot Security Chipset Exit
iEi Feature
⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯
Auto Recovery Function [Enabled]
 Select Screen
↑ ↓ Select Item
Enter Go to SubScreen
F1 General Help
F10 Save and Exit
ESC Exit
v02.61 ©Copyright 1985-2006, American Megatrends, Inc.
Figure A-30: IEI Feature
Step 13: Save changes and restart the system. If the system encounters a Blue Screen of
Death (BSoD) or a hang for around 10 minutes, it will automatically restore from
the factory default image. Step 0:
A.4 Setup Procedure for Linux
The initial setup procedures for a Linux system are mostly the same with the procedure for
Microsoft Windows. Please follow the steps below to setup the recovery tool for Linux OS.
Step 1: Hardware and BIOS setup. Refer to Section
76A.2.1.
Step 2: Install Linux operating system. Make sure to install GRUB (v0.97 or earlier)
MBR type and Ext3 partition type. Leave enough space on the hard drive to
create the recover partition later.