User Manual

ECW-281B/B2-D525 Embedded System
Page 35
4.2.4.2 CF Card Setup
Jumper Label:
JCF1
Jumper Type:
2-pin header
Jumper Settings:
See
765Table 4-3
Jumper Location:
See
765Figure 4-3
The CF Card Setup jumper sets the CF Type I card or CF Type II cards as either the slave
device or the master device. CF Card Setup jumper settings are shown in
765Table 4-3.
CF Card Setup Description
OFF Slave Default
Short 1-2 Master
Table 4-3: CF Card Setup Jumper Settings
The CF Card Setup jumper location is shown in 765Figure 4-3.
Figure 4-3: CF Card Setup Jumper Location
4.2.4.3 Clear CMOS Jumper
Jumper Label:
J_CMOS1
Jumper Type:
3-pin header
Jumper Settings:
See
7765Table 4-4
Jumper Location:
See
7765Figure 4-4