User Manual

ECW-281B/B2-D525 Embedded System
Page 33
Figure 4-1: Bottom Surface Retention Screws
Step 2: Gently remove the bottom surface from the ECW-281B/B2-D525. Step 0:
4.2.4 Configure the Jumper Settings
To configure the jumper settings, please follow the steps below.
Step 1: Remove the bottom surface. See Section
7654.2.3.
Step 2: Locate the jumper settings on the embedded motherboard. See Chapter
765...4.2.4.1.
Step 3: Make the jumper settings in accordance with the settings described and defined
in Chapter
4.2.4.1.