Instruction Manual

ECN-780-Q67 Embedded System
Page 28
Step 3: Insert the VGA connector. Once the connectors are properly aligned with the
insert the male connector from the VGA screen into the female connector on the
ECN-780-Q67. See Figure 3-17.
Figure 3-17: VGA Connector
Step 4: Secure the connector. Secure the DB-15 VGA connector from the VGA
monitor to the external interface by tightening the two retention screws on either
side of the connector.
3.9 In te l
®
AMT Setup Procedure
The ECN-780-Q67 is featured with the Intel® Active Management Technology (AMT). To
enable the Intel® AMT function, follow the steps below.
Step 1: Make sure the memory socket is installed with one DDR3 DIMM.
Step 2: Connect an Ethernet cable to one of the RJ-45 connector LANs which supports
AMT.
Step 3: The AMI BIOS options regarding the Intel® ME or Intel® AMT must be enabled,