Instruction Manual

ECN-780-Q67 Embedded System
Page 27
Step 2: Align the connectors. Align the USB device connector with one of the
connectors on the external peripheral interface. See Figure 3-16.
Figure 3-16: USB Device Connection
Step 3: Insert the device connector. Once aligned, gently insert the USB device
connector into the onboard connector. Step 0:
3.8.7 VGA Monitor Connection
The ECN-780-Q67 has a single female DB-15 connector on the external peripheral
interface panel. The DB-15 connector is connected to a CRT or VGA monitor. To connect
a monitor to the ECN-780-Q67, please follow the instructions below.
Step 1: Locate the female DB-15 connector. The location of the female DB-15
connector is shown in Chapter 3.
Step 2: Align the VGA connector. Align the male DB-15 connector on the VGA screen
cable with the female DB-15 connector on the external peripheral interface.