Instruction Manual

ECN-780-Q67 Embedded System
Page 26
Figure 3-15: DB-9 Serial Port Connector
Step 3: Secure the connector. Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.
Ste p 0:
3.8.6 USB Device Connection
NOTE:
User must install the USB 3.0 driver before connecting a USB device to
the system or else the system may not recognize the connected
device.
There are two USB 2.0 connectors and two USB 3.0 connectors on the ECN-780-Q67. To
connect a USB device, please follow the instructions below.
Step 1: Locate the USB connectors. The locations of the USB connectors are shown
in Chapter 1.