Instruction Manual

ECN-780-Q67 Embedded System
Page 22
Figure 3-11: Audio Connector
Step 3: Check audio clarity. Check that the sound is coming through the right speakers
by adjusting the balance front to rear and left to right.
3.8.2 DVI Dis play Device Connection
The ECN-780-Q67 has one female DVI connector on the rear panel. The DVI connectors
are connected to digital display devices. To connect a digital display device to the
ECN-780-Q67, please follow the instructions below.
Step 1: Locate the DVI connector. The location of the DVI connector is shown in
Chapter 1.
Step 2: Align the DVI connector. Align the male DVI connector on the digital display
device cable with the female DVI connector on the external peripheral interface.
Step 3: Insert the DVI connector. Once the connectors are properly aligned with the
male connector, insert the male connector from the digital display device into the
female connector on the ECN-780-Q67. See Figure 3-12.