Instruction Manual

ECN-780-Q67 Embedded System
Page 19
Step 2: Align the two retention screw holes in each bracket with the corresponding
retention screw holes on the sides of the bottom surface.
Step 3: Secure the brackets to the system by inserting two retention screws into each
bracket as illustrated in Figure 3-8.
Figure 3-8: Mounting Bracket Retention Screws
Step 4: Drill holes in the intended installation surface.
Step 5: Align the mounting holes in the sides of the mounting brackets with the predrilled
holes in the mounting surface.
NOTE:
Please make sure to face the I/O panel sideward (Figure 3-8) when
mounting the system.
Step 6: Insert four retention screws, two in each bracket, to secure the system to the
wall. Step 0: