Manual

ECN-680A-H61 Embedded System
Page 58
Figure 4-18: USB Connector Locations
Pin Description Pin Description
1 VCC_USB 2 -DATA
3 +DATA 4 GND
5 NC 6 VCC_USB
7 -DATA1 8 +DATA
9 GND
Table 4-17: USB Port Connector Pinouts
4.3 Jumper Settings
NOTE:
A jumper is a metal bridge that is used
to close an electrical circuit. It consists
of two metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them.
To CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper means removing the plastic clip
from a jumper.