Manual

ECN-680A-H61 Embedded System
Page 34
Step 4: Locate the RJ-45 connectors. The location of the LAN connector is shown in
Chapter 1.
Step 5: Align the connectors. Align the RJ-45 connector on the LAN cable with one of
the RJ-45 connectors on the ECN-680A-H61. See
360HFigure 3-25.
Figure 3-25: LAN Connection
Step 6: Insert the LAN cable RJ-45 connector. Once aligned, gently insert the LAN
cable RJ-45 connector into the RJ-45 connector. Step 0:
3.11.5 DB-9 Serial Port Connection
There are two RS-232 DB-9 connectors and one RS-422/485 DB-9 connector of the
ECN-680A-H61 for serial device connection. Follow the steps below to connect a serial
device to the DB-9 connector of the ECN-680A-H61.
Step 1: Locate the DB-9 connector. The locations of the DB-9 connectors are shown
in Chapter 1.
Step 2: Insert the serial connector. Insert the DB-9 connector of a serial device into
the DB-9 connector on the rear panel. See Figure 3-26.