Manual

ECN-680A-H61 Embedded System
Page 21
Figure 3-9: Close the CPU Socket
Step 12: Install the fan module in the same position it was before and tighten the eight fan
bracket retention screws. See Section 3.3.
Step 13: Connect the fan connector (CPU_FAN1). See Section 3.3.
Step 14: Replace the cover and secure it using five previously removed retention screws.
See Section 3.3.
3.5 Hard Dis k Drive (HDD) Installation
To install the hard drive, please follow the steps below:
Step 1: Remove four (4) retention screws from the HDD cover, two from the bottom
panel and two from the right side, as shown in
335HFigure 3-10.