Manual

ECN-360A-HM65 Embedded System
Page 50
Setting Description
Short 1-2 Use ATX power (Default)
Short 2-3 Use AT power
Table 4-29: AT/ATX Power Mode Jumper Settings
Figure 4-24: AT/ATX Power Mode Jumper Location
4.4.2 Clear CMOS Jumper
Jumper Label: J _CMOS1
Jumper Type:
3-pin header
Jumper Settings: See Table 4-30
Jumper Location: See Figure 4-25
If the ECN-360A-HM65 fails to boot due to improper BIOS settings, the clear CMOS
jumper clears the CMOS data and resets the system BIOS information. To do this, use the
jumper cap to close pins 2 and 3 for a few seconds then reinstall the jumper clip back to
pins 1 and 2.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
 Enter the correct CMOS setting
 Load Optimal Defaults
 Load Failsafe Defaults.