Owner's manual

ECN-360A-D2550 Embedded System
Page 20
Figure 3-8: DB-9 Serial Port Connector
Step 3: Secure the connector. Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.
Ste p 0:
3.6.4 USB Device Connection
NOTE:
User must install the USB 3.0 driver before connecting a USB device to
the system or else the system may not recognize the connected
device.
There are six USB 2.0 connectors on the ECN-360A-D2550. To connect a USB device,
please follow the instructions below.
Step 1: Locate the USB connectors. The locations of the USB connectors are shown
in Chapter 1.
Step 2: Align the connectors. Align the USB device connector with one of the
connectors on the external peripheral interface. See Figure 3-10.