Owner's manual

ECN-360A-D2550 Embedded System
Page 19
Figure 3-7: LAN Connection
Step 3: Insert the LAN cable RJ-45 connector. Once aligned, gently insert the LAN
cable RJ-45 connector into the RJ-45 connector. Step 0:
3.6.3 DB-9 Serial Port Connection
There are three RS-232 DB-9 connectors and one RS-422/485 DB-9 connector of the
ECN-360A-D2550 for serial device connection. Follow the steps below to connect a serial
device to the DB-9 connector of the ECN-360A-D2550.
Step 1: Locate the DB-9 connector. The locations of the DB-9 connectors are shown
in Chapter 1.
Step 2: Insert the serial connector. Insert the DB-9 connector of a serial device into
the DB-9 connector on the rear panel. See Figure 3-8.