Owner manual

AFL2-W19A/AB-H61 Panel PC
Page 231
Step 12: The recovery tool main menu window is shown as below. Press any key to
reboot the system. St ep 0:
Figure C-21: Press Any Key to Continue
C.3 Auto Recovery Setup Procedure
The auto recovery function allows a system to automatically restore from the factory
default image after encountering a Blue Screen of Death (BSoD) or a hang for around 10
minutes. To use the auto recovery function, follow the steps described in the following
sections.
CAUTION:
The setup procedure may include a step to create a factory default
image. It is suggested to configure the system to a factory default
environment before the configuration, including driver and application
installations.
Step 1: Follow the steps described in Section C.2.1 ~ Section C.2.3 to setup BIOS,
create partitions and install operating system.
Step 2: Install the auto recovery utility into the system by double clicking the
Utility/AUTORECOVERY-SETUP.exe in the One Key Recovery CD. This utility
MUST be installed in the system, otherwise, the system will automatically
restore from the factory default image every ten (10) minutes.